• Adjustable floor supports
• Inclie to 15 degrees
• Guard rails

Bed – 5 1/2" deep x 14 gauge powder painted formed steel channel frame. Bed sections are 10 feet and 5 feet long, bolted together with splice plates and floor supports.
Belt – FS top side, brushed bottom side, with clipper lacing.
Guard rail – 6" high x 16 gauge formed, powder painted steel on both sides, full length of bed sections.
Underside guards – Formed 16 gauge pans full length of bed sections, removable, secured with TEK screws.
Tail pulley – 4" or 6" diameter (see chart) crowned with 1 3/16" diameter shaft.
Drive pulley – 4", 6" and 8" diameter crowned and fully lagged. 4" and 6" diameter pulleys have 1 3/16" diameter shaft, 8" diameter pulley has 1 7/16" diameter shaft.
Snub-roller – 2" diameter for 4" and 6"diameter pulleys, 2 1/2" diameter for 8" diameter pulley.
Return rollers – 1.9" diameter placed on 10' centers.
Floor supports – Adjustable 30" to 44" from floor to top of belt. One floor support provided at each end of conveyor and at each bed joint.
Take-up – 6" long screws located at tail pulley to provide belt tension.
Bearings – Sealed, prelubricated with cast iron housings.
Speed reducer – C-face mounted heavy duty worm gear reducer.
Capacity – 10 pounds per foot maximum live load. See load Capacity.