• Booster conveyor for gravity flow systems
• Transporting between floors
• Center drive

Belt – Rough-top belt.
Bed – 12 gauge powder painted formed steel slider bed. Bed is 6 1/2" deep x 6 feet, 8 feet or 10 feet long spliced together with splice plates.
Under-trussed bed – Extra reinforcement to prevent sag in longer bed sections in addition to reinforcing angles, 24 feet and longer.
Double nose-over – Two 16" long adjustable bed sections provide a two step transition from incline to horizontal with 15° to 35° adjustment.
Tail pulley – 4" diameter, crowned with 1 3/16" diameter shaft through 30" wide belt. 6" diameter tail pulley with 1 7/16" diameter shaft turned down on ends for wider than 30" belt.
Drive pulley – 8" diameter crowned and lagged. 1 7/16" diameter.
Snub roller – 2 1/2" diameter at drive pulley and 2" diameter at tail pulley.
Return idlers – 1.9" diameter, adjustable.
Take-up – Located in center drive assembly, provides 24" of belt take-up.
Pop-out roller – Free floating, 1 3/8" diameter rollers located at tail pulleys with gravity connector rods. Roller will lift out if anything is caught between pulleys and rollers.
Floor supports – Adjustable stands to give 31" to 45" height at each end with knee braces.
Bearings – Sealed prelubricated with cast iron housings.
Speed reducer – C-face mounted heavy duty worm gear reducer.
Capacity – 100 lbs. per foot maximum. Not to exceed Load capacity.