• Transporting between floors
• Booster covneyor for gravity flow systems
• Heavier loads can be conveyed because of less friction build-up

Belt – Rough-top belt.
Bed – Roller bed with 1.9” diameter x 16 gauge galvanized rollers on 6” centers. Rollers mounted in 7" x 1 1/2” x 12 gauge powder painted formed steel channel frames. Frames bolted together with butt couplings.
Under-trussed bed – Extra reinforcement to prevent sag in longer bed sections in addition to reinforcing angles, 20 feet and longer.
X-bracing – Supplied on conveyors 40 feet and longer. Used to square bed sections to insure proper product and belt tracking.
Double nose-over – Adjustable from 0 to 30 degrees.
Tail pulley – 4" diameter, crowned with 1 3/16" diameter shaft through 30" wide belt. 6" diameter tail pulley with 1 7/16" diameter shaft turned down on ends for wider than 30" belt.
Drive pulley – 8" diameter crowned and lagged. 1 7/16" diameter.
Snub roller – 2 1/2" diameter at drive pulley and 2" diameter at tail pulley.
Return idlers – 1.9" diameter.
Take-up – Located in center drive assembly, provides 24" of belt take-up.
Floor supports – Adjustable 31 1/2" to 45 1/2" from floor to top of belt. One support supplied at each end of conveyor and at nose-over, with knee braces.
Bearings – Sealed prelubricated with cast iron housings.
Speed reducer – C-face mounted heavy duty worm gear reducer.