• Heavy duty conveying
• Positive drive
• Pallets
• Heavy drums
• Reversible drums

Bed – 6" x 8.2 lb. and 8" x 11.5 lb. powder painted structural channel frame with powder painted structural channel cross braces in each section. Sections are 5 feet long and bolted together with butt couplings and floor supports.
Tread rollers – 3 1/2" diameter x .30 wall steel tread rollers spaced on 6" or 12" centers, No. 80 sprockets, 1 1/16" hex shaft.
Drive chain – No. 80 roller chain.
Floor supports – Heavy duty structural supports are fixed at 18" elevation from floor to top of roller. One support at each end of conveyor and at each bed joint.
Center drive – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.
Bearings – Removable, sealed, prelubricated ball bearings.
Chain guard – Lower chain guard is mounted on bottom of roller frame, and upper chain guard is mounted above roller frame to totally enclose drive chain.
Speed reducer – C-face mounted heavy duty worm gear reducer.
Capacity – Not to exceed Load capacity.

Available Options
- Side Mounted Drive: Motor/Reducer unit can be mounted to side of conveyor frame for lower elevations. Drive is higher than conveyor frame.
- Conveyor Speed: 30 feet per minute is standard. Other constant, and variable, speeds are available.
- Rollers Set Low: Rollers can be set low in conveyor frame to provide a guard rail effect.