Conveyor Length
|
15 ft
|
Conveying Surface Width
|
41 in
|
Width between Rail
|
45 in
|
Overall Frame Width
|
49 in
|
Weight
|
2609 lb
|
Speed Constant
|
30 fpm
|
Motor
|
2 hp 230/460-3-60 TE motor
|
Capacity per Foot Max.
|
2000 lb
|
Note
|
1Based on 6" Roller Centers
|
- Heavy duty conveying
- Positive drive
- Pallets
- Heavy drums
- Reversible drums
Bed – 6" x 8.2 lb. and 8" x 11.5 lb. powder painted structural channel frame with powder painted structural channel cross braces in each section. Sections are 5 feet long and bolted together with butt couplings and floor supports.
Tread rollers – 3 1/2" diameter x .30 wall steel tread rollers spaced on 6" or 12" centers, No. 80 sprockets, 1 1/16" hex shaft.
Drive chain – No. 80 roller chain.
Floor supports – Heavy duty structural supports are fixed at 18" elevation from floor to top of roller. One support at each end of conveyor and at each bed joint.
Center drive – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.
Bearings – Removable, sealed, prelubricated ball bearings.
Chain guard – Lower chain guard is mounted on bottom of roller frame, and upper chain guard is mounted above roller frame to totally enclose drive chain.
Speed reducer – C-face mounted heavy duty worm gear reducer.
Capacity – Not to exceed Load capacity.
Available Options- Side Mounted Drive: Motor/Reducer unit can be mounted to side of conveyor frame for lower elevations. Drive is higher than conveyor frame.
- Conveyor Speed: 30 feet per minute is standard. Other constant, and variable, speeds are available.
- Rollers Set Low: Rollers can be set low in conveyor frame to provide a guard rail effect.