Frame – Heavy duty 12 1/2" deep x 7 gauge powder painted formed steel channel with heavy duty cross braces. Frames are bolted with spice plates and floor supports.
Rollers – 2 1/2" diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 11/16" hex shaft. Rollers are spaced on 4" or 6" centers, set 7/8" low.
Floor supports – Adjustable 25 5/8" to 30 1/4" (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for eachsupport. Supports on 5 foot centers, change with zone length. Minimum elevation with standard drive location 24".
Drive – Located near center of conveyor length, underneath conveyor frame.
Drive chain – RC #40 for roller to roller connections, RC #60 chain drives each zone. Chains are totally enclosed by metal guards.
Accumulation zones – Standard zone lengths are 60" long with a maximum of 30 zones per single drive.
Electrical controls – Input to a power supply.
Speed reducer – Heavy duty, sealed worm gear, C-face.
Bearings – Non-reversing sealed pre-lubricated with cast iron housing.
Capacity – Minimum unit load - 50 pounds. 4000 pounds maximum unit load.