Frame – Heavy duty 7" deep x 4 gauge powder painted formed steel channel with heavy duty cross braces. Frames are bolted together with splice plates and floor supports.
Rollers – 2 1/4" diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 11/16" hex shaft. Rollers are spaced on 4" or 6"centers, set 2 1/4" low.
Floor supports – Adjustable 18 3/4" to 23 3/8" (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support. Supports on 5 foot centers, changes with zone length.
Drive – Located near center of conveyor length, shaft mount motor and reducer.
Drive chain – RC #40 chain used for roller to roller connections, RC #60 chain drives each zone. Chains are totally enclosed by metal guards.
Accumulation zones – Standard zone lengths are 60" long with a maximum of 30 zones per single drive. Each zone is driven by an air clutch and controlled by a sensor roller.
Electrical controls – 110/1/60 electric solenoid and air switch for discharge zone.
Capacity – 4000 pounds maximum unit load. Total conveyor live load not to exceed Load capacity.
Speed reducer – Heavy duty, sealed worm gear, C-face.
Bearings – Sealed pre-lubricated with cast iron housings.